Brush or Pen Holder

Copyright Claim

Brush or Pen Holder

Boost
71
149
28

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1
A1 mini

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
4 h
1 plate
4.9(25)

Open in Bambu Studio
Boost
71
149
28
6
269
182
Released

Description

This is a simple paint brush or pen or whatever-will-fit holder. It measures 80 x 80 x 160 and has 22 10mm holes and 4 20mm holes for holding anything you need to stand upright.

 

You can use whatever print settings you prefer, but I would suggest a standard .4mm nozzle size, .2mm layer height, three walls on all sides, and 15% cubic or gyroid infill. On a P1P at the standard speed it should take approximately 4 hours to print.

Comment & Rating (28)

Please fill in your opinion
(0/5000)

Great print!
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
easy to print, thanks
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Hard to fully judge since I changed the dimensions, but even with the adjustments, it was an effortless print.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed well
(Edited)
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
great
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
excellent I just put an extra layer at the bottom thank you very much
0
Reply
Scaled it up to 120% for my Artistro acrylic paint pens. I did remix it to remove the bigger holes and replaced them with 2 more rows of smaller holes for a total of 33 placements. Added a 2mm flat fill at the bottom so the pens don't go through to the desk surface.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Great Profile Thank you
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
love the design only down side is that. when moving brush holder ever thing falls out the bottom.
0
Reply
Thx for the boost on my model
0
Reply