Pokemon Halloween Bulbasaur - Halloween season pumpkin on his back!
Kyle_Robots
Shared by
Copyright Claim
Pokemon Halloween Bulbasaur - Halloween season pumpkin on his back!
Kyle_Robots
Shared by
Boost
23
47
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
32 min
1 plate
Boost
23
47
12
0
67
59
Released
Description
This is part of the mix of files: https://www.thingiverse.com/thing:3852091
It is a cute little model of bulbasaur with a seasonal pumpkin on his back.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
If you don't mind me asking what went wrong with the profile so I can improve it saw a rating of 3?
(Edited)1
Reply
Replying to @nairb3D
Honestly I reprinted it and came out great it might have been my filament. The bottom between the legs was super thin.
0
Reply
I will reprint and repost my review!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
hätte stützen benötigt
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good design but this needed supports had a model I had to sand the bottom on
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great except for the back left foot which came detached from the model and the lip overhang did not print properly. It hardly matters to my daughter though, whom the print is for. She took it and I haven't seen it since.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
everything looked great except under the chin and belly. had a bunch of spaghetti string hanging off. layers weren't meshed together. using a bambu x1 carbon and p1s. did the same in both.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld