I actually do print all of the models I upload and that takes a time and filament.
Visit my Patreon (in bio or http://patreon.com/JustBe3D) if you are interested in *exclusive* FREE and members only models or a commercial license to sell your physical prints of my models.
Can be rescaled just remember not to change the Z axis.
I print with a variable layer hight but just uploaded the standard 0.16 base with 0.08 layer heights.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Kingroon Black Transmission Distance: 0.4
PLA Overture Space Gray Transmission Distance: 1.4
PLA Overture White Transmission Distance: 4
PLA Kingroon Black Transmission Distance: 0.4
PLA Overture Red Transmission Distance: 8.2
Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Space Gray
At layer #17 (1.44mm) swap to White
At layer #21 (1.76mm) swap to Black
At layer #22 (1.84mm) swap to Red for the rest.
Your last slider is set to 2.32mm which is lower than the model height.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.