Bambu Lab Internal Poop/Waste Scoop
Remixed by
Copyright Claim
Bambu Lab Internal Poop/Waste Scoop
Remixed by
Boost
19
51
24
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
57 min
1 plate
Open in Bambu Studio
Boost
19
51
24
0
136
133
Released
Description
Remixed 2 models to create this one.
Extended the length to cover the front lip and added clips to both ends so the scooper doesn't move when scooping up filament.
Better to print in 1 piece with a brim to avoid any chance of warping (shouldn't though). It does need supports for the clips (take care when removing supports as you can break the clip)
Alternatively you can easily split it into 2 parts using Bambu Studio and print it standing it up to avoid supports, then Glue it together.
I printed in PLA and it's been fine, but maybe it's better to use high temp filaments.
Comment & Rating (24)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
hard to take a photo of it but printed great and very useful
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice make but tight. because of this is cause it to bow slightly in the middle causing it to raise up.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sehr praktisch
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
love it is one piece. had to print it twice, was too rough in removing supports on the first one and broke it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
easy to print, little supports to remove. great design. thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
not the "scoop" I expected it is sharper and leads to a "track"
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
work well but a pin break
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld