Tesla Model 3 / Y Center Console Tray With Removable Divider Remixed by Print3DZ

Remixed by

Print3DZ

Hobby & DIY>Vehicles

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

3.5 h

1 plate

4.7(10)

Open in Bambu Studio

Boost

114

Released

Description

Update: I designed a new one from scratch that is backlit and completely modular! You can find it here: Tesla Model 3/Y Backlit Modular Center Console Organizer Tray

This is a remix of Constantin's center console tray with removable divider. It is designed to fit in Tesla model Y and model three vehicles.

Changes:

1. I removed the rail at the bottom of the tray as it's not necessary, so that if you remove the divider, you have a completely flat tray.

2. Removed all text from the model as I like a clean look.

Be sure to print the tray in a high temperature filament, so it does not warp.

Hope you enjoy 😊

Comment & Rating (11)

@badbrain3000

Print Profile

0.2mm layer, 2 walls, 15% infill

printed well. I used tree support however since it was recommended by the software

@richardhaas2006

Print Profile

0.2mm layer, 2 walls, 15% infill

Fits perfectly IT even slides perfectly printed in petg

@Behr

This does not fit the model 3 highland. Only models 3's older than 2023

@DennisF

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

I printed it twice. Once for a friend that liked mine and wanted one too. No issues printed without support. But I would recommend variable layer height. I found it slides a bit to easy so I put some rubber on it. I did not try the other models, I think they are needlesly complicated.