Poop Bags Dispenser
Remixed by
Copyright Claim
Poop Bags Dispenser
Remixed by
Boost
12
16
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Boost
12
16
11
0
31
35
Released
Description
Same as the original mode except with the pet initials removed.
Comment & Rating (11)
All
Hello, congratulations on the remix, is it possible to provide the editable file? or make some changes that I think would be interesting. One of the changes is to maintain the side openings (Reduce printing time and material) perhaps make an open pattern on the front also with the same objective, the other change the front overhang so that it is possible to print the entire piece without supports.
Thank you in advance for your attention
The designer has replied
0
Reply
I was able to work with the downloadable STL provided by maker world for remixing. Assuming you have decent CAD software you should be able to import the STL from my remix and make the changes you talked about in your comment.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
had to trim a little from the front overhang for my Amazon branded bags to fit through. other than that, came out wonderfully!
(Edited)The designer has replied
0
Reply
Thanks for the rating!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
too small for regular rolls
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:overhang needs a Support
The designer has replied
0
Reply
worked just fine for me. there have been plenty of other successful prints. I’d recommend looking at your Timelapse to see what caused your failure.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for the rating!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld