Katapult
Print Profile(4)
Bill of Materials
- Ringgummi x 1: Mit der Stärke können Sie selber experimentieren.
Description
This is a fun, easy-to-assemble model. You can use it to fire various small objects such as 3D printed poop or paper balls.
Model Features:
- PLA or PETG
- easy assembly (assembly instructions below)
- approx. 1.5 h total print time
- approx. 20g filament usage
Assembly Instructions:
Remove all supports, and push a piece of filament through the holes to remove supports from them as well.
Take a throwing arm and hold it as shown in the picture
Push an approximately 8cm long piece of filament through the base and the throwing arm
Cut off the excess filament
Next, take a 6cm long rubber band (see picture) and hold it as shown in the picture, and keep one of the three smaller parts ready
Take the small part and slide it into a post of the base part as shown in the picture
Next, lift the small loop created over the post
Repeat the same process mirrored on the other side (on the other post of the base part)
Next, hold the rubber band against the throwing arm as shown in the picture and slide one of the small parts into the throwing arm
Now you have a finished catapult enjoy it😄
Also check out my other models:
Airless 5x5cm ball made of PLA:
If you like this model, then like it, boost it, and follow me🚀
Boost Me (for free)
If you like this model then boost it🚀
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)