Pastamatic 37mm motor remix Remixed by MFDesigns3D

Remixed by

MFDesigns3D

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Standard 0.2mm layer, 3 walls, 20% infill

Designer

1 h

1 plate

5.0(10)

Open in Bambu Studio

Boost

Released

Description

I found this great motor mount for the Pastamatic designed my GekoPrime https://makerworld.com/en/u/939085589. However I found that the motor pretty much ground to a halt when the spool was about 75% full. Not enough power to handle the weight. So I doubled the power! It now runs smooth and fast. Also the motors don't heat up now because they aren't struggling with the weight.

Edit: Check out my spindle stabizer here. https://makerworld.com/en/models/51606#profileId-53330

pastamatic

Comment & Rating (15)

@nicholasivorjoh

This winds a bit slow. Takes quite a long time to wind a spool. Any way to speed it up Maybe slightly bigger gears on the motors?

The designer has replied

@MFDesigns3D

Unfortunately due to the size of the pastamatic gears, this is the biggest that the motor gears can get. But you can buy motors with a higher rpm.

@nicholasivorjoh

Replying to @MFDesigns3D :

Thanks for the reply. I ended up getting some 24v 300rpm motors and these seem to be doing the trick.

@kevman

can you upload that modified bracket that stops the spool from jumping out ?

The designer has replied

@MFDesigns3D

Sorry I'm just seeing this now. I added it. It's actually quite weak and I've had to reprint it a few times. I have plans for something better but just haven't gotten around to coming up with the design. When I do it I'll add it here.

@kevman

Print Profile

Standard 0.2mm layer, 3 walls, 20% infill

Nice model!