Puzzle of Evil - 2.0 by hairyfacedhooman

hairyfacedhooman

Toys & Games>Puzzles

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.16mm layer, 2 walls, 15% infill

Designer

1.8 h

1 plate

4.8(63)

0.2mm layer, 2 walls, 15% infill

1.9 h

1 plate

4.1(9)

Open in Bambu Studio

Boost

214

319

462

Released

Description

This Evil Puzzle will keep you busy for many many hours!

Simply place the four puzzle pieces within the available space.

Sounds pretty easy, doesn't it?

With both an easy and a hard option, no matter your ability, you should find some enjoyment and satisfaction with this small puzzle.

The folding clamshell puzzle can happily hold all four of the pieces even if you've not managed to complete the puzzle, so is perfect to pop in your pocket, bag or keep on your desk.

Printing and assembly advice:

Each part can be printed in one piece, without the need for supports.

The hinge uses a length of filament to fasten the two sides together, with the two hinge pins capping off each side. You may need a little CA glue to keep them in place.

The magnets required are 6x2mm - the same used by Gridfinity
These are readily available on Amazon/eBay/Ali Express.

Don't forget to post pictures of your makes!
Please try to keep them spoiler-free if you've figured out the solutions!

Comment & Rating (89)

@Redev22

Print Profile

0.16mm layer, 2 walls, 15% infill

stunning

@NewYorkTimes

am I missing something, how is it held together

@Redev22

Replying to @NewYorkTimes :

it's a hinge, you cut a piece of filament and stick it inside the hole after aligning the two parts

(Edited)

@NewYorkTimes

Replying to @Redev22 :

another question, do they pieces have a right side up? I would assume the textured side would be the bottom or does it not matter?

@MechanoCraft

Print Profile

0.16mm layer, 2 walls, 15% infill

It's been taking me a long time to solve it... I feel like this could totally be a troll with no solution—it's that hard!

@andrede

Boosted

Okay... puzzle of evil... it sure is. I mean, there are just 4 tiles, how difficult can this be? How? How???.... I printed it with glow in the dark colors for the back. Looks awesome when it gets a little darker in the room. Now, I just need a little more time to solve it.

@MakerMarco

Print Profile

0.16mm layer, 2 walls, 15% infill

Comes out great and really challenging! Haven't figured out the "Hard" puzzle yet. :-(

@izolenta

Print Profile

0.2mm layer, 2 walls, 15% infill

nice

@rjanak

Print Profile

0.16mm layer, 2 walls, 15% infill

Nice print. Haven’t solved it yet though 🤔

@McFly

Print Profile

0.16mm layer, 2 walls, 15% infill

printed perfectly! i didnt need the caps. the filament fitted tightly

@Mr.Nobody

Print Profile

0.16mm layer, 2 walls, 15% infill

such an incredible print it worked so well

@TijsVdB

Print Profile

0.16mm layer, 2 walls, 15% infill

Happy with how it turned out, the hinges were a bit tight, I loosened them up with a thin metal tool before the filament would pass through. I do think the model should be a bit more optimized for colour changes, there are several colour swaps that could be avoided.