I decided to go for a more brown hue for this print, but you can use a more orange/yellow hue if you prefer! A really nice print, 100mm x 73mm in size. An AMS is not required, and I have included a 3MF file that does not use the AMS.

If you do not have an AMS, the ‘No AMS' 3MF file will have pauses instead of a filament change setting. This means the print will pause at the correct layer height and you will have to manually unload and load the filaments in.

If you decide to scale up the model, please make sure you DO NOT enable ‘Uniform Scale’ as this will alter the z height and the swap instructions will no longer be accurate.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA+ Esun Brown Transmission Distance: 1.5
- PLA CC3D Orange Transmission Distance: 7.4
- PLA Sunlu Beige Transmission Distance: 8.2
- PLA Kingroon White Transmission Distance: 7.8

Swap Instructions:
- Start with Black
- At layer #20 (0.92mm) swap to Brown
- At layer #23 (1.04mm) swap to Orange
- At layer #28 (1.24mm) swap to Beige
- At layer #33 (1.44mm) swap to White for the rest.