This is a cap to go over the bolts on a toilet. I noticed one of mine was missing, and I wanted a cap that I could install without unbolting the toilet, and that would stay in place. I designed this to thread on to the top of the 1/4 inch closet bolt holding the toilet down. This may not work for you if your bolts have been cut down too close to the nut.

Although 1/4 inch is the most common bolt size from what I've read, there are other sizes. I have included the f3d file so that you can modify it if necessary. It's also fully parameterized, so you should be able to easily change other things such as height, width, etc.

I did find that when I installed it, I had to force the cap down while turning it, although I seemed to have to do that more on one side of the toilet than the other. I actually suspect this is mostly because the bolts were not cut very cleanly. The important thing is, both caps seemed pretty solid once I got them threaded down all the way. Thread them on so they're fully seated and snug, but don't overtighten. They aren't too hard to strip.

If this design is useful to you, consider a tip or post a make!

Print instructions

Print Settings

Printer Brand: Anycubic
Printer: All-metal Mega
Rafts: No
Supports: Yes (Touching build plate)
Resolution: 0.1
Infill: Unimportant
Filament: 3D Solutech PLA Premium Real White

Notes:

I printed mine at 0.1 layer height to make the threads more accurate. I did have to change a few settings in Cura to make the supports easy enough to remove and to make sure the threads weren't supported.

(1) Supports touching buildplate only
(2) Support overhang angle changed to 75
(3) Support Z distance changed to 0.2