TableTopFatTrack 40" Complete Closed Loop.

I created a wide (86mm) 1/64th scale Hot Wheels & Matchbox friendly Table Top Fat Track for my amusement. I've dumped the clamp idea and went with magnets. Details below. I've also linked to a YouTube video so that it's performance can be evaluated as printing this whole track is a bit of a commitment. The track demonstrated in the linked UTube vid is about 2.5 kilograms. But there's nothing out there like this at the moment. Just others modelling individual pieces and others selling a curve on pay sites. 

The track was made with 1/64th scale RC cars in mind. Most cars work fine. Some of the high end cars and other cars with rubber wheels tend to want to go over the wall. Cars listed as “drift” cars seem to work best. The Hot Wheels RC cars also work very well. Track also works to prevent your RC cars from hitting the floor. 

Link to You Tube Video.

Magnet Holes DIA = 8.2mm x 3.4mm deep. & 13.1mm x 3.4mm deep.

Small N52 Magnet- 1/2" D x 1/8"

https://www.amazon.com/dp/B0DJVSTH5F?ref=ppx_yo2ov_dt_b_fed_asin_title

8×3mm Strong Magnets, Neodymium Magnet.

https://www.amazon.com/dp/B0DHGHMXSG?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Here's links to the cars in the video. I was off a bit on the Mcarro Price. It's closer to $30 not $35 like I said in the vid.

https://www.amazon.com/dp/B0FKB8XLTJ?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

https://www.amazon.com/dp/B0FN3YZ123?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

https://www.amazon.com/dp/B0F2XX8127?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

https://www.amazon.com/dp/B0FHJ74CL7?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1