I had a few areas that didn't print nice, but likely a me problem since it was one of my first test prints.

passt. gefällt.

Easy print. When my garage is finished I will be printing more of these to organize my printing setup and tools.

What a great idea! May I propose to join that with the light weight Skadis grid? https://makerworld.com/en/models/58396#profileId-147585 That would be the total burner :-)

Very good Idea but i'm a little desappointed by the lack of continuity of holes scheme between panels. This discontinuity combined to a wall/panel gap that doesn't fit to the original Skadis panel back gap make me think that there are some ameliorations to bring before perfection ! ;) Thank you for the Idea !

Great print. Printed board could be a bit thicker. Do I remove the tabs not using with the supports? Is this meant to snap and hold together or is it meant to be glued together?

But holes on pieces on picture dont match from sides on picture? Am i right?

In theory, it works well but the pieces that I printed didn't lock into place. I'm better off buying the real thing from Ikea than have to print another batch and throw it out because they don't interlock. Thanks anyway

Easy to print