Bed Scraper (replaceable Scraper) Remixed by Desert3DPrinting

Remixed by

Desert3DPrinting

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Scraper and 5 blades, 0.2mm layer, 2 walls, 15% infill

54 min

1 plate

4.4(5)

Open in Bambu Studio

Boost

Released

Description

Here is a bed scraper with a replaceable “Blade”

Comment & Rating (11)

@igmiller

Print Profile

Scraper and 5 blades, 0.2mm layer, 2 walls, 15% infill

this is a neat idea, the blade connection points are really weak though. my first blade broke really easy. this could benefit from additional thickness at those points.

The designer has replied

@Tridense

Ok, please tell me if you have any ideas on how I can improve the print profile. Otherwise this is a comment on the model and not the profile :)

@Desert3DPrintin

Replying to @Tridense :

It is most likely an issue with the my model, it works pretty good for me, but it might be a little weak were the clips are, but overall it has been great for me.

@RickyA

Print Profile

Scraper and 5 blades, 0.2mm layer, 2 walls, 15% infill

Good idea, but the standard orientation pops the end off a lot. I ended up applying some CA glue to hold it in place because the arms make it a bit too loose and pop off a lot otherwise. I appreciate the intent to reduce plastic consumption by separating out the consumable part.

@stephen.price2

Print Profile

Scraper and 5 blades, 0.2mm layer, 2 walls, 15% infill

(Edited)

The designer has replied

@Tridense

Why 3 stars

@stephen.price2

the file is great, prints easily and is athestically pleaseing. The design was problematic for me. For whatever reason the retention tabs break too easily. My recommendation would be have the blades dovetail into the holder and allow for better attachment. then you could print on its side so you don’t have an individual layer line as the tip of the blade.

@Tridense

Replying to @stephen.price2 :

Ok I understand, but please understand that the rating you give is a rating of the print profile and not the model itself ;)

@Tokolozi

Print Profile

Scraper and 5 blades, 0.2mm layer, 2 walls, 15% infill

printed fine, not the strongest connection for the blade but it works in a pinch. Would reccomend a stronger connection point, not just 2 walls. especially for most who print in PLA.

@max.mustermann.

This design is a good idear but a crap solution. Better would be a front part with a dovetail connection. The tension on the front part is heavy if u have parts that stick very good on the bed.

(Edited)