printed in petg and worked perfectly, fantastic design but... the screw is JUST slightly too short for my cheap desk. I'm planning to solve that by sticking a foam pad onto the screw, to extend the screw and to protect where it meets the desk 👍

This was only my second print on the P1S and it came out beautifully. The screw even works without finishing.

very nice design, thanks!

absolutely love it! nicely done!

works great and no sagging.

perfect

Smooth print, very sturdy and nice finish/quality.

i used petg and it printed fine, the quality looks nice

print profile is OK, some of the female threads didn't print correctly and I had to try a few times to screw the male ones in, basically tapping the hole as inwent. But the real problem is that the screw isn't long enough to clamp to my desk. when the screw is all the way in there is still about a half inch or more space left. I'll have to see if I can use some sort of spacer, which will make it a lot less sturdy and more prone to moving

Perfekt ^^