Simple table top spool holder
Copyright Claim
Simple table top spool holder
Boost
16
36
19
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
55 min
1 plate
0.2mm layer, 4 walls, 30% infill
1.3 h
1 plate
Open in Bambu Studio
Boost
16
36
19
4
141
104
Released
Description
This is a remix of Filamentry's ultimate spool holder: https://goo.gl/tskKCZ
It didn't print well on my printer to hold together properly so I re-designed it with two different parts.
The left part have a threaded stud that fit into the right part and they are both held together by a simple nut. You can see the construction on the cutout.
Yo will need to print two of the "one set" file and will need 4 of the common 608zz bearings.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10%
Documentation (1)
Other Files (1)
SOURCES.txt
Comment & Rating (19)
All
Boosted
Perfect for old Fiberlogic spools🙂
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Printed perfectly. Works a treat.
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Done in silk but still came out almost flawless! My only tiny recommendation is to maybe switch seams to random as the nuts seem to grab a bit each rotation where the aligned seam intersects.
1
Reply
Work fine, fits well
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 10% infill
I like the addition of the screws. Was a huge problem for the original. I modified it to clamp on my spool rack. Will upload as a remix :)
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
Printed well! No fuss about it :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Nice
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
I printed these and four 608 bearings to use in a spool holder for feeding non-AMS filament into my X1C. They work fine!
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld