! Please note that this is an electrical device. Wiring and use is entirely at your own risk.
Use only led bulbs that do not heat very much. !

To be added

• Drawing of model dimensions
• Models for led strip lights (for better light distribution)
• Source step files

You need 1x power cord (I used with a switch) 7x M4x10 screw 1x Bulb socket 1x RGB led bulb
	The model is now ready for two bulb sockets. For another one, send me a message
Push the cable through the prepared hole. Prepare to secure it.
	Connect the cable to the bulb socket. Attach the socket to the bottom of the pencil and secure the cable by tightening the screws.
Screw in the bulb
	Place the cover on the bottom part, turn it over and screw it on with the three M4 screws.
You can also screw on the legs of the lamp. (they are mainly there to lift the bottom part for heat dissipation)
	And it's already lit.