AMS side mount spool holder for X1 and P1S
Copyright Claim
AMS side mount spool holder for X1 and P1S
Boost
131
278
107
Print Profile(1)
Standard 0.2mm str profile
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
131
278
107
4
753
542
Released
Description
Small spool holder for occasional use with flexible filaments that won't work in the AMS.
- Uses stock steel spool holder and screws
- small and quick to print
- Easily removable without tools
- Mounts to AMS housing between plastic ribs
- original will only fit the spot shown
- v3 will fit at other ribs or if you have the version of the AMS of the housing with fewer ribs.
If you like this also check out my buildplate holder for the other side of the AMS:
https://makerworld.com/en/models/27250#profileId-23649
Comment & Rating (107)
All
Print Profile
Standard 0.2mm str profile
printed and nice to fit
(Edited)
0
Reply
This is not the same spool holder... you cant fold it up. I got fooled by the first comment here.
(Edited)1
Reply
Replying to @Jon_Snow
Same. This spool holder doesn't work with my stock screws.
0
Reply
Thanks for the great simple but brilliant answer to the spool on the back problem. I was very impressed by how solid and strong it is.
0
Reply
It's a good idea toput the spools on the side. Where did you get this splitter for the filament (can't find it on the bambulabs site), I have to detach the AMS to use the ext. spool.
0
Reply
Print Profile
Standard 0.2mm str profile
Print looks good, but it seemed to be too tight of a fit It wouldn’t fit in the crack on my AMS and it seemed to almost break the plastic around it. I reprinted it and cut off about 1mm to make sure it would fit in without being too tight
(Edited)
1
Reply
Print Profile
Standard 0.2mm str profile
good And Simple.
0
Reply
Print Profile
Standard 0.2mm str profile
good to go! easy print from the app
0
Reply
Boosted
Print Profile
Standard 0.2mm str profile
printed and works great.
id actually like the tube holder to be slightly longer.
but that’s just a preference.
(Edited)
0
Reply
Print Profile
Standard 0.2mm str profile
In my opinion arm should be little bit linger, but anyway nice design, thanks
0
Reply
Print Profile
Standard 0.2mm str profile
started the print from my phone while being on my way home.
print was successful
0
Reply
Print Profile
Standard 0.2mm str profile
Required a bit of sanding. Printed with Bambu PETG-CF.
0
Reply
works well!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (2)
© 2024 MakerWorld