Print-in-place Hinged Nintendo Switch Cartridge Holder
Boost
45
56
28
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
36 min
1 plate
0.2mm layer, 2 walls, 15% infill
34 min
1 plate
Open in Bambu Studio
Boost
45
56
28
1
93
136
Released
Description
A slim, hinged game card holder that holds up to 4 Nintendo Switch cartridges. Prints in a single piece and snaps securely shut.
Comes in windowless and windowed versions.
After printing, the hinge may need some force to break free and may be hard to move. Opening and closing the case a few times will make the hinge much smoother.
The STLs are oriented diagonally to fit a standard 200mm print bed.
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2 or lower
Infill:
20%
Comment & Rating (28)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
A good case for switch games that fit in my carry case, reminds me of the ones that you get from some carrying cases, which are hard to find.
Used only PLA filament.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
X1C with textured plate.
Done two and they both came out perfect without any hassle.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Awesome no more lost cartridges
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out pretty good.
Only issue I had was the hinge was a tad too slack so the friction catch doesn't work too well, maybe down to my printer/setup
0
Reply
wwwwww
hohe
0
Reply
dis is Not hohe
0
Reply
dis is hohe
0
Reply
hi
0
Reply
Great little model. I fit 4 on the print bed at one time and made a few batches to give away to friends.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
These are perfect and hold the game cartridge so well.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld