Capillary solar water draining clip (with source files!)

Copyright Claim

Capillary solar water draining clip (with source files!)

Boost
10
33
5

Print Profile(3)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

improved support, 0.2mm layer, 2 walls, 25% infill
improved support, 0.2mm layer, 2 walls, 25% infill
Designer
20 min
1 plate
5.0(1)

ASA with supports
ASA with supports
19 min
1 plate
4.7(3)

PLA Fit Test
PLA Fit Test
11 min
1 plate
5.0(1)

Boost
10
33
5
0
65
61
Released

Description

This capillary water drain clip is designed to remove the most of the water from my solar modules (10° tilt):

Over time, dirt will accumulate on the edges of the module, because small puddles tend to form at the bottom end.

I would recommend printing these clips in ASA or some other UV resistant material.

Printed with 0.2mm layerheight and tree supports (see picture for parameters).

 

I'm using 2 clips per module. They are placed on the bottom outer edges right next to my cable management clips, which you can find here:

Solar cable management clip

 

I've added more variants for other modules which have been requested in the comments.

If you need other dimensions for frame or clamp width, just leave a comment and I'll upload it.

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Print Profile
improved support, 0.2mm layer, 2 walls, 25% infill
Muy buena calidad
(Edited)
0
Reply
Print Profile
ASA with supports
useful
0
Reply
Print Profile
PLA Fit Test
0
Reply
Print Profile
ASA with supports
0
Reply
Print Profile
ASA with supports
0
Reply
No more