Search models, users, collections, and posts
puzzle cube 2
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
38 min
1 plate
Open in Bambu Studio
Boost
1
2
0
0
0
0
Released
Description
this puzzle cube was built by my little sister I hope you like it
(side note this applies to my previous puzzle cube and will probably apply for all of my project until I can use my phone for photos but I know the irl photo is bad but I need it to have the project not get taken down)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)