ROSA3D Refill Bambu Lab Spool Adapter
Copyright Claim
ROSA3D Refill Bambu Lab Spool Adapter
Boost
24
35
26
Print Profile(2)
0.16mm layer, 3 walls, 15% infill
1.7 h
1 plate
A1 mini, 0.24, PETG, 2h13min
2.2 h
1 plate
Open in Bambu Studio
Boost
24
35
26
4
136
135
Released
Description
I needed an adapter that would fit from cardboard cartridges from ROSA3D, in order to print with AMS.
Unfortunately, all the projects I found were either too big, too small, or ones where the roll rolls over the printed adapter.
The model has curved ridges to better grip the cardboard center of the spool, and has a cutout for the Bambu Lab wedge in the spool.
I suggest printing it with at least PETG to have the ability to dry the spool above 60C.
Print instructions:
2-3 walls
4 top/bottom layers
15% GYROID infill
Comment & Rating (26)
All
Print Profile
0.16mm layer, 3 walls, 15% infill
pasuje idealnie do szpuli.
3
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
functions as intended but you need to use some force to get it to fit
2
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
super adapter
2
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
a little tight
The designer has replied
1
Reply
it have to be tight
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
snug fit on printed bambulab spool but works!
2
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
really hard to fit the spool in it but with some pressure ots ok. I used some wd40 to make it slide.
1
Reply
hard fitting but great overall model
1
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Adapter works ok.
(Edited)1
Reply
Boosted
Print Profile
0.16mm layer, 3 walls, 15% infill
2
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
2
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld