Airplane Device Holder
Airplane Device Holder
Boost
25
50
14
Print Profile(2)
0.16mm layer, 3 walls, 35% infill
Designer
41 min
1 plate
0.2mm layer, 6 walls, 25% infill
44 min
1 plate
Boost
25
50
14
1
75
112
Released
Description
A small tablet holder to hook to an airplane table.
Holding together by magnets
The middle holder isn't really necessary, just made it to hold 2 devices a bit overlapping in the middle.
Comment & Rating (14)
All
Print Profile
0.16mm layer, 3 walls, 35% infill
It worked on three out of four shelves. And it really helped me a lot on my last trip :)
I had no problems with PETG.
I didn't print the small airplanes. Everything great. Thank you :)
0
Reply
Boosted
what size magnets did you use?
0
Reply
was looking for something like this after my last flight. Printed perfectly on P1S. Still need to test it and if its strong enough (printed in PLA)
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
Great print and great tool!
0
Reply
Boosted
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 35% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld