Filament spool stand by marcgdm

marcgdm

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

1.9 h

1 plate

4.9(60)

A1 Mini, 0.2mm layer, 3 walls, 30% infill

4.5 h

2 plates

5.0(3)

Open in Bambu Studio

Boost

168

477

339

Released

Description

Simple, with 4 x 608 bearings.
Wide, because the coils are not all the same width.

Length (axles 115mm)
Width (for coils, about 120mm / 4.72")
I've added rubber pads so it doesn't slip...

spool holder

Comment & Rating (73)

@steven.schoen20

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfekt für meine 2,5kg greeny+

@ME3DPrint

Thanks. The ball bearings didnt really fit on my printout. A bit loose, they just fell off. Would be better if they fit snugly to the spindle or to the frame. Its nice simple design.

(Edited)

@AeonJoey

Boosted

I added a dab of hot glue for that reason to mine, working well, peels off easily in case you want to remove it

@cblte

Thank you for the model. Works nice and is helping me now to print from the unusual formed Fiberlogy filament spools. I might add some rubber pads, or felt pads below. The bearings went on super easy and when you do not need it, just store it somewhere. I might fix the bearings with some superglue so they always stay one. But for now, they also go easy off the rods and I can reuse them then when I print the spool winder. But for now, it stays where it is, and it works as it should! Thumbs up!

(Edited)

@joshstubblefiel

Print Profile

0.2mm layer, 2 walls, 15% infill

love this model!! works so well!!

@UncoolJohn

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed easily and works well. I wish the pegs were a little tighter, but I just used some hot glue like others have mentioned. A lot easier to swap than the back mount.

@user_1479947888

Print Profile

0.2mm layer, 2 walls, 15% infill

Excelente y funcional

@lacroserocks

Boosted

Came out great, fits a Polymaker 3kg spool. I tried using printed 608 bearings with some silicone grease, but the spool seems too heavy for them. Have real 608's on the way.

@AeonJoey

Boosted

came out gorgeous, looks so handsome in this bambu silver PLA. nice model! I had spare 608s from building a pastamatic, so this was a perfect print :)