Flexi US Flag
Copyright Claim
Flexi US Flag
Boost
24
34
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.7 h
1 plate
Open in Bambu Studio
Boost
24
34
11
0
79
58
Released
Description
Flexi of the US Flag. The profile is painted, if you use the .step file you will need to paint it yourself.
Comment & Rating (11)
All
This errant red spot on the model wastes a lot of time and filament and on mine is resulting in one end of the model being slightly pink because even with the prime tower there is red bleed through in the white. Otherwise very nice. Thanks!
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice. Thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints out looking really good, flexi is a little on the tight side. It has one small spot on the top that the red goes all the way down therefore wasting more filament than neccessary. Overall its great, I would print again.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice flag like the look of it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect and Printed Well
0
Reply
secret Russian
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld