I was sick of having all of my tools scattered about on my table so I decided to design a simple side mounted rack for my ARC enclosure to hold them all. It simply uses the same screw holes as the side panel with four M3x8 screws. It holds up to two builds plates, the Bambu scraper tool, a regular glue stick, a Bambu Lab liquid glue stick, a pair of snips, and the two included hex keys. The bottom piece needs to be printed separately then glued on before installation. I printed and tested V1 but am yet to test V2. The changes in V2 include:

-Making more space for the snips as they were interfering with the scraper

-Raising the back to make it easier to slide in the rear build plate

-Shrinking the glue stick slot to better fit

-Adding the hex key holder

-Rounding off some edges.

Everything should work with V2, but there is a chance the hex keys or the glue stick will not fit so let me if everything works if you print V2.

Print settings:

Filament: iSanguh Violet Mirage PETG

Resolution: 0.16mm

Infill: 15% Gyroid

Support: Yes

I also only used only 1 wall loop and 2 top and bottom layers to save on filament.

If you have any other questions feel free to ask and happy printing!