Glass Shower Door Razor Hook
Copyright Claim
Glass Shower Door Razor Hook
Boost
57
102
28
Print Profile(4)
0.2mm layer, 3 walls, 15% infill
Designer
37 min
1 plate
1 piece - PETG - 0.2mm layer, 2 walls, 10% infill
37 min
1 plate
2 pieces - PETG - 0.2mm layer, 2 walls, 10% infill
44 min
1 plate
All Bambu Printers - Optimized Supports - PETG Recommended
52 min
1 plate
Boost
57
102
28
2
159
150
Released
Description
Needed some hooks for my sliding glass shower door which is 6mm thick. I made this to be 6.1mm thick and it fits perfect. 4mm walls all the way around allows for perfect clearance between my shower doors and the frame.
Supports were needed and I printed this on its side for better layer adhesion. 1 hook took 36 minutes & 2 hooks took just 46 minutes at .2 and all other normal settings other than the following settings: 3 walls, 15% infill w/adaptive cubic pattern. Printed in PLA to start for prototyping but may print in PETG after I see how these hold up.
Comment & Rating (28)
All
Print Profile
1 piece - PETG - 0.2mm layer, 2 walls, 10% infill
thank you..🙏
(Edited)
1
Reply
My pleasure, I got tired of having razors all over the edge of the tub, this was a quick and easy fix.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfekt , passt super und der Druck ist schnell erstellt
The designer has replied
0
Reply
Thank you very much
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed fine - it seems like glass thickness is standardized to 6mm, as it is the same for me :)
The designer has replied
1
Reply
I’m glad it worked out for you as it did me.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Good Print, nice job!
The designer has replied
1
Reply
Thank you. Hopefully it’s working out for you.
0
Reply
Good Idea!
The designer has replied
1
Reply
Thank you
0
Reply
Print Profile
All Bambu Printers - Optimized Supports - PETG Recommended
great print
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
1
Reply
Glad you like it
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
1 piece - PETG - 0.2mm layer, 2 walls, 10% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld