Search models, users, collections, and posts
Simple Doorbell
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
46 min
2 plates
Open in Bambu Studio
Boost
3
4
0
0
2
1
Released
Description
I made a simple doorbell that uses a waterproof button as I found the cheap ones did not really satisfy my needs.
It copies the screw spacing from a standard doorbell. You can use a screw terminal or just solder your wires to the button.
Screw the baseplate to your doorframe, attach the wires and clip the housing on.
It uses these standard 12mm ‘high’ pushbuttons:
https://www.amazon.nl/-/en/GUUZI-Button-Momentary-Waterproof-5-Pack/dp/B09BMRDPTN
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)