Stealth Fighter F-117

<Board Game Miniature Collection>--<Warship Collection>--<Aircraft Collection>--<Vehicle-Tank Collection>--<Aerospace Collection>

Stealth Fighter F-117 Nighthawk

Nighthawk Fighter - F-117

Single cockpit, movable wings and canopy, glue is required for assembly.

This is a highly detailed model, optimized for easy printing. This model has been specifically optimized for 3D printing.
Printing Tips:
build plate: Use a textured PEI plate.
filament: PLA
Layer Height: 0.12mm
Outer Wall Count: 2
Acceleration: Set all acceleration to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be required. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI build plate to ensure good adhesion, and ensure your filament is dry.
Special thanks to all friends for your attention, likes, downloads, and support!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.12mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your material is dry.

Special thanks to all friends for your attention, likes, downloads, and support!

USS George H.W. Bush, the tenth and final Nimitz-class aircraft carrier built for the United States in the early 21st century.