Bambu Lab X Carbon and P1S Door Holder
Copyright Claim
Bambu Lab X Carbon and P1S Door Holder
Boost
25
49
44
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
32 min
2 plates
Open in Bambu Studio
Boost
25
49
44
0
107
83
Released
Description
This is a holder to keep the door open on the Bambu Lab X carbon or P1S when using the textured plate with PLA. This keeps the chamber for getting too hot. There are two sizes. A long and a short one. This will keep the door from bouncing around if you have it slightly open.
Comment & Rating (44)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
fits perfectly and has a nice clean look to it
The designer has replied
1
Reply
Thank You!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
works great
The designer has replied
0
Reply
Did you print it out of TPU? Thanks for the rating.
0
Reply
Replying to @dclutter
its an old clear blue PLA. but i was thinking TPU would work a lot better as it wants to bend due to the angle of the door.
0
Reply
Works great! this is one of those times where you say why didn't I think of this. Brilliant! For the people that are having problems with it staying on the cabinet when the door is open just move it to the bottom of the case and it will stay.
The designer has replied
0
Reply
Good Idea!
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
stampata in petg per una maggiore elasticità
The designer has replied
0
Reply
Thank you!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
printed long and short as seen here in bambu basic pla, defiantly worked last night as I had a 7.5hr print in pla going
The designer has replied
0
Reply
Awesome! Thanks for the rating!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Nickel, merci
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
works well. wish it would stay in place when I removed models.
The designer has replied
0
Reply
humm mine does. I can try uploading one that is a little tighter. I will let you know.
0
Reply
I have uploaded a new version that is tighter on the case side.
0
Reply
Thats so cool, and a good idea
lg chris
The designer has replied
0
Reply
Thank You!
0
Reply
printed the short version in green bambu pla - 0 issues. thank you!
The designer has replied
0
Reply
Thank You!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Both sizes came out great.
(Edited)0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld