This is the Part of the Controler, that connects the joystick knob with the Part on the PCB.
My one broke off, so I needed to design a new one and here it is. Maybe someone else had the same problem. :)
Printer:
Anet A8
Rafts:
Yes
Supports:
Yes
Resolution:
0,1 layer height
Infill:
100%
Notes:
It would be the best if you use only Walls and no Infill. The nozzle is then moving like in vase mode, whats much better on this small size.
The Controller, for that the part is.
The Part of the Controller, that must be replaced
The Replacement