Easter Vasemode Egg by Dr.D

Dr.D

Household>Decor

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Vasemode Try-150% Scale: 0.6mm layer width with 0.4mm nozzle

38 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

105

Released

Description

Want to print something useless?
My Vasemode Egg

Possible in Vasemode setting
But maybe try…

-normal Mode
-1 Wall line
-adaptive print layers
-no infill
-no support, not even your Mum

Check Out my other Stuff, and Models on my

Makerworld Page.

https://makerworld.com/en/@Wanja

and follow me for more Design Updates :P

https://makerworld.com/en/models/405427

https://makerworld.com/en/models/403537

If you read this, you will be my Valentine

Ps. leave a comment if you also saw the tags ;)

Comment & Rating (15)

@Leif3D

Wondering if it was ever printed successfully or just rendered? It keeps failing at the same spots - whether it's printed in vase mode or normal mode with 1 wall. It's also designed way smaller than the render suggests.

The designer has replied

@Wanja

Hi, I uploaded my print, so it is possible :D Maybe you can use adaptive Layering so that you got more detail on the Top. I also printed it in the Original Scale 10cm tall that also helps with less extreme overhangs.

@Leif3D

Replying to @Wanja :

Thanks for the reply, the scale might be the issue then because I've also tried adaptive layers before. When the STL gets opened it's just 1.38mm in height and after letting the slicer convert it to mm it's just 35mm tall. I'll give it another try scaled up to 100mm 👍

@Leif3D

Replying to @Wanja :

Ok failed again while trying it at a 10cm height. It's the top few centimeters where the angle / overhang gets too extreme for vase mode or a just a single wall.