Planter coexistence by Dr.D

Dr.D

Household>Decor

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Out (Left Planter) 0.24mm layer, 3 walls, 15% infill

5.4 h

1 plate

5.0(2)

In (Right Planter) 0.24mm layer, 3 walls, 15% infill

4.5 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Ying and Yang

If you have both pots, the plant gods will have mercy on you forever.
You must always print both pots, otherwise all the plants will die.

Glue the feet with some hot glue and you're done.

Check Out my other Planters, and Models on my

Makerworld Page.

https://makerworld.com/en/@Wanja

and follow me for more Design Updates :P

https://makerworld.com/en/models/405427

https://makerworld.com/en/models/406043

If you read this, you will be my Valentine

Ps. leave a comment if you also saw the tags ;)

Comment & Rating (6)

@user_3597660376

i would love to print these for mothers day but they would need to fit a 5" pot in them, do you know what scale % i would need to print them in? I am new to printing and not sure that that number is. Thanks! will definitely Boost and Rate if can figure it out.

The designer has replied

@Wanja

Im living in the metric system :D But if my measurements are correct you should scale it up to 125%. You could also try just to print the base or the top oft the planter and measure it just to be sure

@user_3597660376

Replying to @Wanja :

Printed the "out" at125% and the "in" is 2 hours into its print. The OUT printed perfectlyand the IN is looking great so far as well. Quick question, I see your description says to just hot glue the feet to the bottom - when the OUT printed there were no placement holes for the 4 feet, and I see placement holes for the feet on the IN version - is this normal? should there be placement holes on the OUT as well? I'm assuming the guide holes not only ensures perfect placement of the feet but adds some strength to the joint as well.