Bambu Lab Nozzle Wiper X1 / P1 3mm Silicone by devilinside

devilinside

3D Printer>3D Printer Parts

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 50% infill

Designer

24 min

1 plate

4.8(6)

Open in Bambu Studio

Boost

Released

Description

Mein Düsen Abstreifer (Nozzle Wiper) für den Bambu Lab X1..

Passt perfekt in den Schacht, ohne den Originalen Abstreifer zu entfernen und verrutscht nicht.

Habe eine Silikon Matte mit einer Dicke von 3mm verwendet.

Grösse ca. 16x12mm.

Obere Abstreifkanten leicht mit einem Messer abgeschrägt ^.

Bitte mit Support drucken.

Am besten ABS, ASA, PC oder andere hitzebeständige Materialien benutzen.

PLA ist nicht geeignet!!!

My nozzle wiper for the Bambu Lab X1..

Fits perfectly into the shaft without removing the original scraper and does not slip.

I used a silicone mat with a thickness of 3mm.

Size approx. 16x12mm.

Upper scraper edges slightly chamfered with a knife ^.

Please print with support.

It is best to use ABS, ASA, PC or other heat-resistant materials.

PLA is not suitable!!!

Comment & Rating (13)

@3dprint4Life

DOWNLOAD THE ORIGINAL : https://makerworld.com/en/models/145761#profileId-158636 . Dude you remixed this model and he didn't allow to do it!

The designer has replied

@devilinside

Sorry, it's not a remix of a model!!! Similar function, but not the same. Dude

(Edited)

@3dprint4Life

Replying to @devilinside :

C'mon man you remixed his model , he doesn't allow it and it's not only the function similar: same corners, same distance and edges. You just open a hole and the square in the middle, insert the silicon wiper like he exactly did, so you post your model assuming like it's your original idea (allowing license remix) and it's not.

@devilinside

Replying to @3dprint4Life :

Again!!! This isn't a remix or anything like that. If you put both models in the middle, you can see the differences. Yellow is mine. Red is his. These are clear differences.

(Edited)

@user_1836869223

Print Profile

0.2mm layer, 3 walls, 50% infill

@3DTut

It works great, BUT it gets pooped on after the first layer check, the nozzle goes directly on the right side it the silicone holder. It there a way to stop that?

@3DTut

For anyone having the same issue, turn off first layer inspection to stop the poop in the wrong place.

@podenkh

Print Profile

0.2mm layer, 3 walls, 50% infill