flower pot and saucer
flower pot and saucer
Boost
19
29
14
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
4.1 h
2 plates
Boost
19
29
14
0
149
131
Released
Description
The model of a flower pot with a saucer will fit perfectly into any interior, it is great for growing orchids and other flowers. It is recommended to print with PETG plastic, since the flower pot has holes to remove water, and the flower pot retains water to maintain plant life. Время печати с оптимальными настройками составляет примерно 4 часа.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
great pot and saucer. profile worked awesome!
The designer has replied
1
Reply
Thanks for the feedback! Good luck to you
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
1
Reply
Thanks for the feedback! Good luck to you
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Ben fatto profilo di stampa consigliato
The designer has replied
1
Reply
Thanks for the feedback! Good luck to you
0
Reply
cool model! printing it right now
The designer has replied
1
Reply
Thanks for the feedback! I tried to make a simple geometry of a flower pot and saucer without any problems. I searched a lot for simple ready-made models of pots and saucers, but I never found them.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld