ProPlex RC Prop Case

H2S / H2D Accessory Toolbox – Reinforced Remix

This model is a remix of the original H2S / H2D Accessory Toolbox by maxim3D.
Full credit goes to the original designer.

This version is shared under the same CC BY-NC-SA license.

About This Version

This remix focuses on improving print reliability and structural strength while keeping the original layout and functionality.

Specifications

• Pin diameter: 4 mm
• Fixed pin grid layout
• Hinged lid design
• Integrated front latches
• Side compartment for additional accessories

The 4 mm pin size is optimized for secure accessory placement while maintaining easy removal.

Improvements

• Reinforced hinge geometry
• Optimized tolerances for smoother assembly
• Cleaner internal geometry
• Tested for reliable printing on Bambu printers

Recommended Print Settings

• 0.2 mm layer height
• 4 walls
• 25–30% infill
• PLA or PETG
• Supports only where necessary

License

This model is released under the Creative Commons Attribution–NonCommercial–ShareAlike license.
Commercial use is not permitted.

Please credit the original creator if you further remix this design.