Cupholders for Mazda MX-5 NA
Copyright Claim
Cupholders for Mazda MX-5 NA
Boost
1
8
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
1
8
3
1
15
12
Released
Description
This cup holder is designed to fit into the ashtray slot of the first-generation Mazda MX-5 (NA). It is a simple and elegant design that is easy to install and remove. The cup holder is sturdy and stable, and it can accommodate a variety of cup sizes.
Features:
- Easy to install and remove
- Sturdy and stable
- Accommodates a variety of cup sizes
Printing Instructions:
- Print the cup holder in ABS or PLA filament.
- Use a 0.2mm layer height and 20% infill.
- No supports are required.
Post-Printing Instructions:
- Remove the cup holder from the build plate.
- If necessary, sand the edges of the cup holder to smooth them out.
- Install the cup holder in the ashtray slot of your Mazda MX-5.
Comment & Rating (3)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
mal sehen ob es passt! aber toll!
The designer has replied
1
Reply
Looks perfect! :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This is a great design that fits perfectly. The overhangs did not print very nice as you can see in pictures 1/2 but by flipping it over and using supports I was able to get a nicer finish on the top. May upload my print profile later for others to try.
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld