chessboard Mod Holes enlarged
Remixed by
Copyright Claim
chessboard Mod Holes enlarged
Remixed by
Boost
4
5
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10.9 h
5 plates
Boost
4
5
1
0
13
15
Released
Description
I slightly enlarged the holes on the board. Because the 2mm diameter rod didn't fit me. Now it fits well!
It's not too loose that it slips out, but goes in well, I nudged it in with a small hammer.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Had slight issues with adhesion but slowed the print down a bit and it worked perfectly then. Used Marbled, Silk and matte Pla. Will upload picture when I get Rod Installed
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld