Sealed AMS Rear Desiccant Tray By SSILBER Shared by vexedmouse09

SThane

Shared by

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 6 walls, 35% infill

4 h

1 plate

4.9(16)

Open in Bambu Studio

114

110

Released

Description

This is a simple reupload of SSilber's dessicant holders for the AMS. The print file is multicolor white and black. All credit should be give to SSilber, all I am doing is uploading his models on here for users.

Comment & Rating (16)

@TBone_427120

Print Profile

0.2mm layer, 6 walls, 35% infill

Printed in clear PETG. Fits together very snugly.

@morganmbk

Boosted

Print Profile

0.2mm layer, 6 walls, 35% infill

Printed great! Door a little tight though. Had to file it to fit. I like the one-piece top with small fill hole. It does not fall apart when I take it in and out of my AMS. Much better than the two-piece removable top others have that comes off and spills beads everywhere. Thanks for sharing!

@jameswcurtis

Print Profile

0.2mm layer, 6 walls, 35% infill

this printed great and fit perfectly. it was a little difficult to get the chute together, but once it did, it worked well also. With the new software showing the hygrometer number showing for the AMS my number went from 4 to 1 in a matter of hours. The floral dessica.t I bought is a little messy, but it does the jov.

@Ryan14

Print Profile

0.2mm layer, 6 walls, 35% infill

Print was great. Doesn’t fit in with the factory covers but does a great job at bringing humidity down. With the dual colors I kind of like the no factory covers. Great print. Thank You!