The filament I used had a weak bond between the layers, so the front panel came off.
Since it can be used without problems even if the front panel is removed, I created a version that is omitted.
It's basically the same design as the original, but both sides have been changed.
The left panel has widened holes. This is due to plug interference.
The right panel has added solid around the cord hole for added strength.
The EL model Zelda edition dock didn't fit, so I unfolded it.
You should be able to set the initial model and the EL model.
I drilled a hole so that the LED can be seen.
i haven't printed it yet.
2023/05/08
Added installation photos.
Initial lot, Zelda edition, USB port, cable port.
Fixed the LED display.
Earlier versions would hide the initial dock LEDs.