Clip honeycomb laser
Copyright Claim
Clip honeycomb laser
Boost
56
93
45
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
38 min
1 plate
Boost
56
93
45
6
248
199
Released
Description
Clip Honeycomb laser - Xtool Laser / Ortur Laser OLM3 … / Creality Falcon Laser / Elegoo Phecda Laser / ATOMSTACK Laser….
No matter your brand of laser, these little honeycomb clips are perfect and compatible with all plate models !
Simple and quick printing, designed to fix your plates before engraving! They can be easily stored in the honeycomb plate guide that we have printed (take a look at our library!)
Comment & Rating (45)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
easy print I did have to scale up slightly to work on my honeycomb bed though
The designer has replied
1
Reply
Thank's @damionstorm for you'r feedback ! and thank's you so much for you'r boost ! 🤩
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Thanks for sharing
The designer has replied
1
Reply
Thank's for you'r feedback :D
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print, fits my bed perfectly. Holds down firmly but is still easy to remove. I printed out a dozen of the short and long tabs so I will always have some on hand when needed. Thanks!
The designer has replied
1
Reply
Super cool! Thanks for your feedback :)
0
Reply
Imprimé sur ma Ender3 pro c'est parfait ! Merci Jordan
The designer has replied
1
Reply
Avec plaisir :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Quick print that's fitted great when I needed it
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The clip is thin and come off easily from sculpfun honeycomb, so I had to increase diameter to fit better.
The designer has replied
1
Reply
Thank's for your feedback! You should not hesitate to vary the scale of the clip by +/-5% to adapt it to your equipment!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
These were to small, scaled them up and on first use they broke
The designer has replied
0
Reply
Perhaps a wrong setting or poor quality filament! We've printed a lot of them and all is well here 😂
0
Reply
Replying to @ZouzouFactory
Fresh Bambu PLA
Settings from Profile
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed perfectly (that's an adverb), even with high speed PLA.
The designer has replied
1
Reply
Thank you HardStryker :D
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked perfectly for my honeycomb bed,
The designer has replied
1
Reply
Really cool ! Thank's for your feedback
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld