Bambu Lab Aux Fan Full Plate Cooling 7/28 by brody.bolanos

brody.bolanos

3D Printer>3D Printer Parts

Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

PLA P1

Designer

1.4 h

1 plate

5.0(3)

PLA X1

Designer

1.4 h

1 plate

5.0(3)

ABS DualFanX1 - 0.2mm layer, 2 walls, 15% infill

1.1 h

1 plate

5.0(2)

Boost

154

174

Released

Description

Upgraded fan duct attachment for https://makerworld.com/en/models/23658

The X1 and P1 Version are different! This is to account for the Lidar clearance.

If you like my designs and want to say thanks, you can buy me a coffee and help fund the filaments I need for prototyping. A donation of any amount to Buy Me a Coffee or PayPal would be greatly appreciated!

Comment & Rating (18)

@Pak1979

I use the dual Aux fan with my Bambu X1C and have a litle problem with it. Is it possible to create a version that has the same height as the original Aux fan duct? There is the following problem when printing PLA. The original fan starts to cools from layer 4 upwards, but the second fan duct located lower down and cools the buildplate and the first 3 layers and this creates warping on the right side from the prints. You can see the different heights of the fan ducts on the printbed in the picture...

(Edited)

The designer has replied

@brody.bolanos

How did you wire it? The best way is to tap into the original aux fan, then they turn on the exact same time. Also something is wrong with this, they SHOULD be the same height but I'm not sure why yours is sitting so much lower. What are the exact files you downloaded?

@Pak1979

Replying to @brody.bolanos :

The cabling is on the Bambu aux fan of the X1C. That is why there is the problem. If the original fan cools in the 4th layer, the second fan also goes on as planned, only it cools the lower layers because the fan duct is lower. I used your "Bambu Lab P1 / X1 Series Modular Bentobox Aux Fan" with the new duct "Bambu Lab Aux Fan Full Plate Cooling" and installed everything and screwed it to the metal rail as described in the instructions... I compared the new duct with the two from your other models, the height is the same for all of them. I don't know if Bambu Lab have made the Aux Fans a bit higher since they are no longer glued but screwed to the case?

@brody.bolanos

Replying to @Pak1979 :

Can you take a height measurement of the whole assembly? But it wouldnt matter how the original fan is mounted because either way it only goes as high as the frame railing above it.

(Edited)

@blazentrance

Boosted

Print Profile

ABS DualFanX1 - 0.2mm layer, 2 walls, 15% infill

Perfect for dual Aux fan!

@BeeSeL

Print Profile

PLA P1

works

@m0larMechanic

Is there a way to improve the fan on the left side of the x1c as well?

@soyfer

Print Profile

PLA P1

Perfect to have a second auxiliary fan.

@lindnjoe

This worked out perfect! I used the x1 version for both p1p and x1c and both turned out great. I wired it where it runs with the other fan in sync. Bravo on this!