This is a 5 color hueforge print of Castiglione's Pines and Cranes in Spring. For the 5th color if you have an AMS unit you just swap out one of the colors that has already printed and won't be used again. When I did it I waited for the green to swap out at layer 12 and then swapped the red in because I already had white in the AMS.

In my print for the brown I used a copper color filament I had and think it turned out nicely.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Overture Black Transmission Distance: 0.7
PLA BambuLab Basic Green Transmission Distance: 2
PLA Overture Black Transmission Distance: 0.7
PLA BambuLab Basic Red Transmission Distance: 4
PLA Kexcelled Light Brown Transmission Distance: 3.5
PLA Jayo White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Green
At layer #12 (1.04mm) swap to Black
At layer #13 (1.12mm) swap to Red
At layer #15 (1.28mm) swap to Light Brown
At layer #20 (1.68mm) swap to White for the rest.