IKEA Skadis - Hook
Copyright Claim
IKEA Skadis - Hook
Boost
267
645
184
Print Profile(4)
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
20 min
1 plate
two hooks, A1 mini, 0.2mm layer, 6 walls, 25% infill
20 min
1 plate
a1 mini, full plate, 0.2mm layer, 6 walls, 25% infill
1.5 h
3 plates
X1C Save filament
19 min
1 plate
Boost
267
645
184
3
1.5 k
1.2 k
Released
Description
This design works with 2 hooks, which is easy to install and remove, but holds very well thanks to the small bumps on the hooks:
Print instructions
- I used PLA, but any material should do
- No supports needed
- 4+ perimeters for added stiffness
Comment & Rating (184)
All
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
very useful hooks thanks
1
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
Prints Great and fits like a charm. Recomend!
1
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
prints fast, strong hook, fits great
1
Reply
Print Profile
two hooks, A1 mini, 0.2mm layer, 6 walls, 25% infill
Maybe a little bit tight at first, but does it's job well.
0
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
great
0
Reply
Print Profile
two hooks, A1 mini, 0.2mm layer, 6 walls, 25% infill
Great design. My go-to skadis hooks.
0
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
firm and good
0
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
simple, stable and uses little filament, what not to like
0
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
love them, thanks for satisfying my OCD
0
Reply
Print Profile
Two hooks, strong, 0.2mm layer, 6 walls, 25% infill
nice
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld