Simple laptop stand designed to fit on bed 18x18cm. You can scale it up for any bed size. I use it with Huawei Matebook 14.

There are 2 models for different laptop thickness.

For laptop like Matebook 14 (16mm thickness) use 20mm version:

For laptop with thickness greater than 20mm, use 30mm version:

Tips:

Height of the stand when printing is 20mm, which is good compromise between print time and stand stability. In case you want to have more stability, just adjust Z dimension of the model in your slicer.

It is also recommended to use some tape / rubber pads on the bottom of the stand to prevent sliding.

Print instructions

• I used PLA, but any material will do
• No supports needed
• 3 perimeters are enough, but 4+ perimeters for added stiffness
• 0 top and bottom layers
• 10% honeycomb infill
• 3MF and gcode with above setting included