Fishing Rod Holder Large
Copyright Claim
Fishing Rod Holder Large
Boost
13
24
6
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
13
24
6
0
42
31
Released
Description
Simple fishing rod holder if you don't like your rod sections banging around in the storage. This one should fit most large, heavy rods.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Printed ok, except the first couple of layers due to the fillet on the edge. They cleaned up ok with a heat torch though.
The designer has replied
0
Reply
Thank you for the feedback @Rick269 ! I modified the models to arrange the small problems you mentioned. Updated all three.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld