Basket to replace the one that comes with the Pearl/Supreme/Janta watch cleaning machine.

For file "Basket_v1" The hooks at the top have to be cut after it's printed. But this requires no supports.

"Basket with L" requires supports to print the hooks.

My print ended up with a bit too much room so I made a space ring to close up some space so the spring could hold the baskets tighter.

Added v2 of the basket with tear drop shaped holes so there is less bridge failure at the top of holes.

The Basket Meshed3 and Meshed4 uses parts modifiers to make the mesh.

3D Printed Resin Clean Tray with Infill Mesh! - YouTube

If you are using a parts dryer I would recommend printing this at minimum in ABS. Would be better if you could use some Nylon. Inside the drying chamber I measured temps over 100C. So with ABS I wouldn't put it all the way in the chamber. There will still be enough heat to dry the parts.

Custom Section

Category: Gadgets