Drill Guides by Bear | No supports | Improved version
Copyright Claim
Drill Guides by Bear | No supports | Improved version
Boost
1
8
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
54 min
1 plate
Open in Bambu Studio
Boost
1
8
3
0
19
13
Released
Description
Hi there! I needed to make a few holes around the house to make some installations and dust was an issue. Decided to design my own guide and dust collector to make it look the way I wanted.
V2.0
There were several changes from the previous version. My old model is quite popular so I had a lot of feedback. Some people commented the main guides were breaking on them, so I tweaked a little the design to make them stronger, as illustrated below.
Another new feature is I added some little rulers into the design. Left hand is a small 50mm ruler and the right hand is a small 2 inch ruler.
And finally, some aesthetic modifications, I really liked the result.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Guides broke off after a couple uses. Interesting idea but might need something tougher than pla to work better or a stronger design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for leaving a review =D
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld