Frozen Olaf Headset Holder
Frozen Olaf Headset Holder
Boost
58
66
5
Print Profile(1)
0.1mm layer, 4 walls, 15% infill
Designer
33.7 h
3 plates
Open in Bambu Studio
Boost
58
66
5
3
79
15
Released
Description
Olaf Headset Holder/Stand
My wife loves Frozen and her PC setup is a “frosty” theme, so this little guy fits right in!
Parts separated for printing without an AMS, but the main head is colored for ease of use IF you do have an AMS. If not, just print it white and then paint a few places and boom… OLAF!
There isn't too much small detail, so you can print this in .2 layer height just fine :)
Check out my other stuff!
| Bokoblin Chest Toolbox | Tri-force Door Handle | Sheikah Slate Cover | Master Sword Dust Cover |
 |  |  |  |
Comment & Rating (5)
All
Print Profile
0.1mm layer, 4 walls, 15% infill
quelques petits ratés, mais cool dans l’ensemble ! merci !!
0
Reply
Print Profile
0.1mm layer, 4 walls, 15% infill
cool model
0
Reply
Print Profile
0.1mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.1mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.1mm layer, 4 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld