Zelda Sheikah Slate Cover for P1P/P1S

Hey listen!

Legend of Zelda: Shiekah Slate Cover for P1P/P1S Screen!

I have been trying to come up with ways to make my printer feel more like “mine” and less “commercial?".
I decided to decorate my printer in a Zelda theme. Here is my attempt at adding some flair to the lackluster control module installed on these printers.



This model is printed with supports to keep the bottom from looking terrible from the overhangs. I believe I used a brim on this due to bed adhesion issues, but you can take it off for your print if need be.

Print this with .2mm layer height or below. I printed with .2 because I didn't care about fine detail, but printing this with .08 will make it look crispy. I designed this to print and just slide over the module with no gluing or screwing or doing. I had a bit of troubleshooting on mine to make it work and wound up printing it a bit too big, so I printed a 3mm cushion and glued it to the inside of the hole so now it fits. I went back into the model and shrunk it a few mm, so it should fit better now, but not be too tight for tolerance issues.

If you have any issues or need me to redo anything, please let me know. I will do what I can to adjust it for you!

Thank you! Please check out my other models below and feel free to download them!

Master Sword and Hylian Shield + Mount	Zelda Tri-Force Door Handle for P1P/P1S